System
105 System Data
4-14 Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
20 Transit Counter Select the Networking Transit Counter. This device limits the number of nodes
through which a QSIG call can pass before being terminated as a lost call.
Possible values: 0~128 (default = 1)
21 Primary Clock
22 Secondary Clock
Enter data as xxyyzz.
zz=channel 01 if clock source is RPTU or RDTU
zz=channel 01, 02, 03 , or 04 if clock source is RBUU/RBUS or RBSU
Example: If the Primary Clock Source should be a assigned to an RPTU in
cabinet 5, slot 2, enter 050201.
Cabinet numbers:
CTX100: Select 01 for Base and Expansion cabinet.
CTX670: Select 01 for Base and 02~07 respectively for each Expansion
cabinet.
Slot numbers:
CTX100: Select 01~04 for Base slots and 05~08 for Expansion slots.
CTX670: Select 01~08 for Base slots and 01~10 for Expansion slots.
23 Call History Prefix 1 Add the dialing prefix 1 when using the callback feature in Call History.
Possible values: Add (default) or Do Not Add
24 Emergency Digits Sent Enter an alternative emergency dialing string. If no value is entered in this field
any previously programmed value is overwritten.
Possible values: Up to 5 digits (default = 911)
25 DP Make Ratio Select the Dial Pulse Make/Break ratio.
Possible values: 33% (default) or 40%
26 Call Button Jumping Select whether to execute Jumping LED.
Possible values: Enable (default) or Disable
• If enabled, line calls move from a telephone DN button to a line button after
they are answered. After answering the call, the DN button is cleared to
receive another call.
With this operation the DN acts as an answer button for the telephone. This
operation only applies if the line that is answered has a button (CO/GCO/
Pooled) appearance on the telephone.
• If disabled, line calls remain on the DN after they are answered.
FIELD DESCRIPTION
To Next Page
Loading...
