Station
Assignment
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03 5-15
Station
214 DSS Console Assignment
Prerequisite Program: 200 on page 5-1
This assignment allows up to eight Direct Station Selection (DSS) Consoles to be assigned to a station. The
assignment is referenced to the stations’s Primary DN.
1. From the Program Menu, click
Station > Assignment.
2. Click on the DSS tab (shown
right).
3. Enter a DN number in the
Primary DN field
...or click one of the following
buttons:
• List – view a summary list of
programmed DSSs.
• Extended List – view a
detailed list of programmed DSSs.
4. Enter the Equipment number in which the DSS(s) is installed.
5. Click Submit.
FIELD DESCRIPTION
Prime DN Enter the PDN of the station that is to be associated with the DSS console(s).
Possible values: Any string up to 5 digits (default = no value).
01~08 DSS Equipment
No. 1~8
Enter the DSS equipment number as xxyyzz.
Cabinet – Select 01 for Base and Expansion cabinet (CTX100). Select 01 for
Base and 02~07 respectively for each Expansion cabinet (CTX670).
Slot – Select 01~04 for Base slots and 05~08 for Expansion slots (CTX100).
Select 01~08 for Base slots and 01~10 for Expansion slots (CTX670).
Example: If the DSS console should be connected to a PDKU or BDKU/BDKS in
cabinet shelf 5, slot 2, circuit 3, enter 050203.
If a PDN is assigned to the DSS equipment number it must be deleted, using
PRG201, before attempting to assign the DSS console.
To Next Page
Loading...
