Station
ISDN
5-32 Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
FIELD DESCRIPTION
Primary DN Enter the PDN. When a required DN is not programmed, the DN is regarded as a
new station. The System assigns default data as defined in 217 ISDN Station Data
.
Possible values: Up to 5 digits (default = no value)
01 PDN Equipment No. Enter the BRI equipment number assigned to this PDN. This is the cabinet, slot,
and circuit number of the RBUU/RBUS or RBSU/RBSS interface PCB to which the
the PDN is, or should be, assigned. Enter data as xxyyzz:
Example: If the PDN should be a assigned to a BDKU in cabinet 5, slot 2, circuit 3;
enter 050203.
Cabinet numbers:
CTX100: Select 01 for Base and Expansion cabinet.
CTX670: Select 01 for Base and 02~07 respectively for each Expansion cabinet.
Slot numbers:
CTX100: Select 01~04 for Base slots and 05~08 for Expansion slots.
CTX670: Select 01~08 for Base slots and 01~10 for Expansion slots.
02 ISDN Channel
Group
Enter the ISDN Channel Group number.
Possible values: 1~32 (CTX100), 1~48 (CTX670 Basic)1~128 (CTX670 Exp.)
(default = 1)
03 ISDN Protocol Select the ISDN protocol. Only Bearer capabilities specified by the protocol can be
entered in this field. The Initial value for ISDN Protocol corresponds to information
set in the hardware level.
Possible values: Nat’l ISDN (default), ETSI, TTC or Nat’l ISDN Nortel
Note National ISDN = North America, ETSI = England and TTC = Japan.
04 Type Connection Select connection type.
Possible values: Point to point (default) or Point to Multi-point
05 BRI Station COS
• Day1 COS
• Day2 COS
• Night COS
Select the BRI Station COS assignments.
Possible values: 1~32 (default = 1)
06 BRI Station DRL
• Day1 DRL
• Day2 DRL
• Night DRL
Select the BRI Station DRL assignments.
Possible values: 1~16 (default = 1)
07 BRI Station FRL
• Day1 FRL
• Day2 FRL
• Night FRL
Select the BRI Station FRL assignments.
Possible values: 1~16 (default = 1)
To Next Page
Loading...
