Strata CTX Programming 04/03 xi
Introduction
This manual provides information required to program the Strata CTX business telephone system
using Toshiba’s CTX WinAdmin™ software or Button Programming.
Important! This programming manual only applies to CTX WinAdmin versions higher than
version 1.10. If you have CTX WinAdmin 1.10, refer to previous versions of this
manual: Part Number CTX-MA-PRGRM-VA.
Organization
Part 1: Getting Started
Chapter 1 - Programming Guidelines describes auto-recognition features, order of
programming, and overview of general CTX WinAdmin and Button Programming operation.
Part 2: CTX WinAdmin Programming
Chapter 2 – CTX WinAdmin Overview provides general information about CTX WinAdmin’s
software capabilities.
Chapter 3 – Installation discusses system hardware and software requirements for
CTX WinAdmin and includes the installation steps needed to install CTX WinAdmin.
Chapter 4 – System provides system programming information.
Chapter 5 – Station discusses station and station feature programming.
Chapter 6 – Trunks explains trunk programming information including T1, ISDN Basic Rate
Interface (BRI) and Primary Rate Interface (PRI).
Chapter 7 – Attendant describes Attendant Console support and settings available in
CTX WinAdmin.
Chapter 8 – IP Telephone describes the programs required to program IP Telephone features.
Chapter 9 – Services discusses programming of services available to Strata CTX through
CTX WinAdmin.
Chapter 10 – Operation explains system setup options available to CTX WinAdmin users.
System initialization, SmartMedia formatting, system software upgrades and Internet Protocol (IP)
configuration are among the topics discussed.
Chapter 11 – Maintenance provides system and component trace program information.
CTX WinAdmin Configuration and Flash Memory Testing are also described.
To Next Page
Loading...
