Trunks
ISDN
6-24 Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
14 Initialize Type Enter the Service Profile Identifier (SPID) type of initialization.
Possible values: User Entry (Auto SPID On), User Entry (Auto SPID Off), Auto
SPID or None (default)
15 Initialization Display Enter the text to be displayed for SPID Initialization.
Possible values: Up to 4 ASCII characters (default = User)
16 SPID #1 Enter the SPID value. These fields are required if you selected National ISDN in
Protocol. When no data is entered, any previously entered information is
overwritten.
Possible values: Up to 20 ASCII characters (default = No Value)
17 SPID #2
18 T-Wait Timer Enable the T-Wait Timer. This field is needed if you selected National ISDN in
Protocol above. This timer, used along with the SPID, assigns random initializing
SPID times to prevent BRI interfaces from re-initialize at the same time after a
reset or power outage.
Possible values: Enable or Disable (default)
19 Voice Calls Select the number of simultaneous voice (speech) calls that can exist at the same
time on this interface.
Possible values: One or Two (default)
20 Trunk Subscriber 1 Enter the telephone number for subscriber 1. Telephone number should be
consistent with D channel data. If no data is entered in this field any previously
programmed information is lost.
Possible values: Up to 10 digits (default = no value)
21 Trunk Subscriber 2 Enter the telephone number for subscriber number 2. If no data is entered in this
field any previously programmed information is lost.
Possible values: Up to 10 digits (default = no value)
Table 6-7 Bearer Capability Table
Bearer Services
Bellcore
National ISDN
ETSI TTC
Circuit Mode
Speech X X X
3.1 KHz X X X
7 KHz X X
Unrestricted
Digital
Information
64 Kbps X X X
Rate adaptation
from 56 Kbps
X
2x64 Kbps X X
FIELD DESCRIPTION
To Next Page
Loading...
