IP Telephone Programming
150 System IP Data Assignment
8-2 Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
02 Terminal
Authentication
Enable this parameter if you want to reserve the PDNs on IP Telephones
system wide.
When “enable" is set, terminal authentication by MAC address of IPT is valid.
So if another IPT with the same PDN is connected to the network, CTX rejects
the registration of this IPT because the MAC address of IPT is different.
When "disable" is set, you can move the PDN from a IPT to another IPT and
another IPT can be connected to the CTX.
In program 250 FB05 is the same parameter exists. Prgoram 250 FB05, the
individual IPT setting will override this system wide setting.
Possible values: Enable or Disable (default)
03 Diffserv Enable Diffserv (Differenciated Services) priority control if voice packets on an
IP (internat) Network should be prioritized with priority tagging. Higher priority,
time-critical BIPU\IPT voice traffic can have preferential treatment when other
traffic is running at best effort.
If Diffserv is enabled you must set the '04 TOS Field Type' as DSCP or TOS.
Note:Diffserv is usually not standard feature with most ISPs, contact your ISP
to amke arrangements to provide Diffsrv or this feature will not work accurately.
Possible values: Enable or Disable (default)
04 TOS Field Type If '03 Diffserv' is enabled, select DSCP 'Differinciated Service Format' or TOS
'Type Of Service format'.
Then, if TOS is selected, set the packet prioritiy level in '05 TOS Precedence
Type'.
Then, if DSCP is selected, set the packet prioritiy level in '06 DSCP'.
Possible values: Tos (default) or Dscp
05 TOS Precedence Type If TOS is selected in '04 TOS Field Type' select a packet priority level - where
CRITIC/ESP provides the highest and Routine provides the lowest priority.
If TOS is selected in '04 TOS Field Type' make selections in TOS Delay, TOS
Throughput Delay, and TOS Reliability Type.
Possible values: Routine, Priority, Immediate, Flash, Flash Override, or
CriticEsp (default = 0)
TOS Delay Type If TOS is selected in '04 TOS Field Type' select 'Normal' for most cases.
Possible values: Normal (default) or Low
TOS Throughput Type If TOS is selected in '04 TOS Field Type' select 'Normal' for most cases.
Possible values: Normal (default) or High
TOS Reliability Type If TOS is selected in '04 TOS Field Type' select 'Normal' for most cases.
Possible values: Normal (default) or High
06 DSCP If DSCP is selected in '04 TOS Field Type' select a priority level from 1~ 64.
Level guidlines:
0,Best effort, default for most non-voice IP traffic.
24, Assured Flow 'AF' or Controlled Load, intended to classify streaming traffic.
40, Expedited Flow 'EF' or Guarenteed, intended to classify high priority traffic.
Possible values: 0~63 (default = 0)
FIELD DESCRIPTION
To Next Page
Loading...
