Toshiba Strata CTX - Page 24

Strata CTX Programming Guidelines
Step 1: Use Default Auto-programming to Start Up
1-4 Strata CTX Programming - Part 1: Getting Started 04/03
Table 1-4 Auto-Programming of Line Groups and Service Types
009 RCIU2+RCIS
4 or 8 Caller ID
interface
Caller ID interface for RCOU/RCOS
and RGLU analog CLID lines. Note:
The same Prg100 code (009) is used
for RCIU2 with or without RCIS.
010 RMCU+RCMS
2 or 4 E911 analog
CAMA lines
CAMA lines Note: The same Prg100
code (009) used for RCIU2 with or
without RCIS.
011 REMU, BVPU
4 analog Tie lines, 4
VoIP circuits
Tie lines
012 RBSU
2 ISDN BRI (S/T)
circuits
TIE Type:
Two TIEs
ISDN BRI CO lines
013 RBSU+RBSS
4 ISDN BRI (S/T)
circuits
TEI Type:
Two TIEs
ISDN BRI CO lines
014 RPTU
16 or 24 ISDN PRI
channels
PCM Highway:
16 or 24
1
ISDN BRI CO lines
015 RBUU
2 ISDN BRI (U)
circuits
TEI Type:
Two TIEs
ISDN BRI CO lines
016 RBUU+RBUS
4 ISDN BRI (U)
circuits
TEI Type:
Two TIEs
ISDN BRI CO lines
1. If the slot next to an installed RDTU or RPTU is vacant, 24 line or channels will be installed; If the slot next to
an installed RDTU or RPTU is occupied by another PCB, 16 lines or channels will be installed.
CO line type
OLG
Prg 306
ILG
Prg. 304
CO Service Type
RCOU/RCOS and RGLU analog loop
and ground start
11
Direct In Termination (DIT) to the first PDN.
(200 or 2000 – see Table 5)
RDDU analog DID 1 2 DID, wink – no default DID numbers
RDTU (T1) 1 3 DID – no default DID numbers
RMCU/RMCS analog CAMA 1 -
Direct In Termination (DIT) to the first PDN.
(200 or 2000 – see next table)
RBUU/RBUS and RBSU ISDN BRI -
set as CO side
24DID – no default DID numbers
ISDN PRI 25DID – no default DID numbers
REMU analog E&M 3 6 Non-QSIG
1. The line number is assigned to all lines in the numerical order according to the line PCB cabinet placements.
Example: Line number 1 will be on the first circuit of the line PCB placed in the lowest cabinet/slot number.
2. OLG:1 is created even if there is are no analog line PCBs installed.
Table 1-3 Auto-Programming for CO line PCB Recognition (Program 100)
(continued)
PCB
Code
PCB Name PCB Circuit Type Parameter setting Comments