Operation
911 Remote Program Update
10-12 Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
Important!
● If power is turned off/on or if the Strata CTX is re-started before switching the Active software from
“Trial” to “Normal”, the CTX670 will switch the old software back to Active.
● It is your responsibility to verify the system is working correctly after Remote Update is complete.
Notes
● If the new version of software is not performing properly, on the CTX670 only, you can activate
the old version of software again by initiating a Clear-reboot.
● Clear-reboot swaps the active and standby sides of flash memory. You must always install a
SmartMedia card containing a copy of the current back up data before initiating a Clear-reboot or
all programmed data will be erased.
● If the CTX100 system is not working properly with the new software, you must reinstall the
original software using this Update procedure.
Table 10 Program Update Screen Field Descriptions
FIELD DESCRIPTION
Upload from Folder Select the Strata CTX type.
Possible values: CTX100_R_MXnnn, CTX670_R_MXnnn.
Version Number Software version number displays. Example: A102MXnnn00. See CTX Software
Identification.
Number of Files Displays number of files that have to be uploaded. This file is static.
Files Uploaded Displays number of files uploaded. This is a dynamic field and will change during
the process.
Operation
Completion
View operation status.
Copied blocks View number of blocks copied.
Possible values: 0~65536 (default = 0)
Total Blocks View total blocks to be updated.
Possible values: 0~65536 (default = 0)
Active Side ID Active Side Number.
Possible values: 0 or 1 (default = 0)
Active Side Status Software status display.
Possible values: Normal (default), Trial, Fault, Don’t care or Error
Standby Side Status Standby Backup Type. This field will display only when connected to a CTX670. It
will not display when connected to CTX100.
Possible values: Normal (default), Trial, Fault, Don’t Care or Error
To Next Page
Loading...
