Telephone Button Programming
200 Series Programs
13-28 Strata CTX Programming - Part 3:Telephone Button Programming 04/03
200-08 Station QPL
• Day1 QPL
• Day2 QPL
• Night QPL
)%
, n,
6SNU
, n,
6SNU
, n,
+ROG
n = 1~16 QPL for Day1.
QPL for Day2.
QPL for Night.
200-09 Station Name
)%
, n,
+ROG
n = Up to 8 digits Station Name to be displayed on LCD (Cannot be entered from DKT
in R1).
200-10 Call Waiting Tone for
Offhook Camp-on
)%
, n,
+ROG
n = 1. None
2. Singular
3. Continuous
Call Waiting Tone of Offhook Camp-on.
200-11 Dialing Progress Tone
)%
, n,
+ROG
n = 1. Dial Tone
2. Entry Tone
3. Quiet Tone
Type of Tone to hear after dialing LCR access code.
200-12 System Call Forward
Group Number
)%
, n,
+ROG
n = 0~4 (CTX100)
0~10 (CTX670 Basic)
0~32 (CTX670 Exp.)
System Call Forward group number.
200-13 Call Pickup
)%
, n,
+ROG
n = 1. Permitted
2. Group Only
3. Not Permitted
The station privilege to activate Call Pickup.
200-14 Bearer Capability –
3.1KHz
)%
, n,
+ROG
n = 1. Audio
2. Speech
ISDN Bearer Capability the PSTN is expecting from non ISDN
stations. 3.1kHzAudio or Speech.
200-15 Display DN
)%
, n,
+ROG
n = Up to 5 digits The number displayed on the calling telephone that rings this PDN
number. The number displayed on the called telephone when calling
from any DN on this telephone.
This number will be overridden by PRG209, 04 (if assigned) and if the
PDN is in a hunt group.
200-16 Caller Emergency
Service Identification
(CESID)
)%
, n,
+ROG
n = Up to 16 digits E911 Calling Party Information identifier for this station (CESID).
Note CESID should be 10 digits or less for Centralized Automatic
Message Accounting (CAMA) E911 trunk. PRI E911 allows
pot 16 digits.
200-17 Emergency Call
Group
)%
, n,
+ROG
n = 1~8 The Emergency call group that this station belongs to.
200-18 Remote CF/DND
Password
)%
, n,
+ROG
n = Up to 4 digits Password to remotely set or cancel DND or station Call Forward from
another CTX station, or for Call Forward only, from a external DISA
line.
Note DND can not be set/canceled remotely from a DISA line.
200-19 VMID Code SMDI
)%
, n,
+ROG
n = Up to 16 digits Enter the voice mail box number that should answer calls when this
PDN calls voice mail, or when this PDN is called and then forwards to
voice mail ( this number is prefixed by codes in Program 579, 11~16).
Valid entries: digits 0~9, * and #, maximum 10 characters.
This VMID code is sent to the voice mail device in SMDI packets or
DTMF tones on direct calls to voice mail from the PDN and on calls to
the PDN that forward to voice mail (see Program 580 for SMDI or
DTMF choice).
200-22 Message Waiting to
VM Port
)%
, n,
+ROG
n = Up to 5 digits Message Waiting Center DN.
Programs 200~202 (continued)
Button Sequence Value(s) Summary
To Next Page
Loading...
