Toshiba Strata CTX - Page 335

Telephone Button Programming
300 Series Programs
Strata CTX Programming - Part 3:Telephone Button Programming 04/03 13-57
Telephone Button
Programming
306-09 FRL
)% , n, 6SNU , n, 
6SNU
, n, +ROG
n = 1~16
(default = 1)
Select Day 1, Day 2 and Night Values.
306-10 QPL
)% , n, 6SNU , n, 
6SNU
, n, +ROG
n = 1~16
(default = 1)
Select Day 1, Day 2 and Night Values.
306-11 Speech/3.1 KHz
)% , n, +ROG
n = 1. Audio (default)
2. Speech
Bearer Capability 3.1 KHz Audio or Speech.
306-12 MOH Source
)% , n, +ROG
n = 1. Quiet Tone
2. External 1 (default)
3. External 2
4. External 3
5. External 4
6. External 5
7. External 6
8. External 7
9. External 8
10. External 9
11. External 10
12. External 11
13. External 12
14. External 13
15. External 14
16. External 15
Select MOH Source.
306-13 Account Codes
)% , n, +ROG
n = 1. Enable
2. Disable (default)
Enable Trunk forced Account Codes.
306-14 Destination
Restriction
)% , n, +ROG
n = 1. Enable
2. Disable (default)
Enable Destination Restriction.
306-15 Credit Cart Calling
)% , n, +ROG
n = 1. Enable
2. Disable (default)
Enable Credit Card Calling.
306-16 Send CESID
)% , n, +ROG
n = 1. Enable
2. Disable (default)
Enable CESID sending.
306-17 QSIG Sending Type
)% , n, +ROG
n = 1. Cut through (default)
2. Senderized
Digit sending Mode for QSIG only.
306-18 Network COS
)% , n, +ROG , +ROG
n = 1~32
(default = 1)
Select Network COS number.
307
OLG Delete
 , +ROG
This command deletes Outgoing Line Groups.
307-00 OLG Number
n,
+ROG , +ROG
n = 1~32 (CTX100)
1~50 (CTX670 Basic)
1~128 (CTX670 Exp.)
Enter the OLG number to delete.
308
Trunk Timers
 , +ROG
Assigns trunk timers for analog and T1 trunks.
308-00 Trunk Equipment No.
xxyyzz,
+ROG
xx = Cabinet 1 (CTX100),
01~02 (CTX670 Basic),
01~07 (CTX670 Exp.)
Enter the trunk equipment number.
Note Equipment numbers are required when assigning a new trunk
to the system. It can also be used to display the equipment
location of existing trunks.
yy = Slot 01~8 (CTX100),
01~10 (CTX670)
zz = Circuit 01~24
Programs 303~315 (continued)
Button Sequence Value(s) Summary