Strata CTX Programming - Part 4: Appendices 04/03 A-1
Applications, Tips and
Tricks
Applications, Tips and Tricks A
Voice Mail Set Up
The following steps/program sequences are provided as a guideline to programming System Voice Mail
settings.
Note Enter programming mode before step 1. Refer to “Enter Program Mode” on page 13-7. Press +ROG
each time you want to save your settings and press
before you move to the next step.
Analog Ports
1. Program 100 “Card Slot Assignment” on page 13-11. Assign the PCB for Voice Mail ports (RSTU).
2. Program 200 “Station Data” on page 13-27. Verify FB1~FB4.
• FB03 Circuit Type – Assigns Voice Mail to be assigned to PDNs associated with Voice Mail RSTU
circuits.
• FB15 Display DN – DN to be displayed and assigned to Hunt Group. Manually assign DNs and
equipment.
3. Program 209 “Station Hunting Group” on page 13-45. Voice Mail Group is determined by the Hunt
Group.
4. Program 218 “Station Hunt Group Assignment” on page 13-49.
5. Program 579 “System Voice Mail Data” on page 13-87. Complete FB01~FB17.
Notes
● FB10 Central Message Callback – Enter the node ID and hunt group for voice mail. Used for
centralized voice mail SMDI only.
● DTMF – Message Waiting Call Back DN across QSIG TIE lines. DTMF integration uses the number
that displays in Program 200, field 15.
6. Program 580 “Voice Mail Port Data” on page 13-88. This is the collection of all ports.
7. Program 803 “IO Logical Device Assignment” on page 13-92. You can add members to the hunt group.
Assign BSIS RS-232 port for SMDI.
Note System only provides Code 300 for SMDI. Code 301 is not supported.
8. Program 804 BSIS RS-232 Serial Port setup.
9. Program 309 “Direct Inward Dialing” on page 13-58.
• FB11 DNIS VMID Code
• FB15 DID/DNIS Number DTMF VMID
10.Program 318 “DID Intercept Assignment” on page 13-65.
• FB11 VMID for DNIS Number
• FB15 DID/DNIS Number DTMF VMID
To Next Page
Loading...
