Applications, Tips and Tricks
IPT1020-SD Telephone Network Settings
Strata CTX Programming - Part 4: Appendices 04/03 A-7
Applications, Tips and
Tricks
IP Telephone Installation and Network Connection setup
1. Install the IP telephones using instructions in the IPT chapter of the CTX Installation and Maintenance
manual.
2. From each IP Telephone, set its network connection parameters using the “369Hold” program mode
(refer to the instructions that follow).
Notes
● Some IP telephones parameters must be set from each individual IPT using “369Hold” programming.
These parameters remain stored in the IP telephone even if the telephone is unplugged. This allows the
telephone to be moved to different locations without reprogramming.
● Other IPT parameters must be set in IP Telephone > Station IP data (Program 250) in WinAdmin.
Initially, the parameters in WinAdmin are normally kept at defaults.
IPT1020-SD Telephone Network Settings
This section explains how to enter data for your IPT1020-SD telephone. Before you begin, make sure that
you have the following information: IP address, subnet mask number, router address, Station ID, CTX
Strata Net node number, IP address for the BIPU-M1A, etc.
Notes
You may want to enter a period or backspace when performing the following steps. While in programming
mode [Press
++++ROG (simultaneously) to enter programming mode], you can use these buttons for
the following functions:
• Press
to enter a period.
• Press
9RO ▼ to backspace.
• Press
6SNU to cancel entry and start over.
To Next Page
Loading...
