Applications, Tips and Tricks
IPT1020-SD Telephone Network Settings
Strata CTX Programming - Part 4: Appendices 04/03 A-9
Applications, Tips and
Tricks
IP Telephone Start Up Sequence
After the IP telephone network setting has been programmed, the following displays occur after the IP
telephone is hung-up:
Action LCD Indication Remarks
1. IPT
initializes.
2. IPT
searches
for IP
address.
Possible errors:
• IP address is
not set.
• No DHCP
server, etc.
If error occurs, IP address setting is carried out
continuously.
3. IPT
searches
for BIPU.
Retries every 10 seconds.
Possible errors:
• BIPU is not
found “time
out.”
• BIPU is not
found (Station
ID automatic
setting).
• BIPU is not
found
(StationID
manual setting)
• Multicast
address is
not
registered (BIPU IP address setting mode is
automatic setting by multicast)
• BIPU IP
address is not
registered
(BIPU IP address setting mode is manual
setting.
4. Registering
to BIPU
When registering fails, IPT retries by starting at
Step 2 again.
Error message:
“Exxx” is error
number.
5. Registering
completion
- normal
action.
LCD data is indicated from
CTX. Example:
To Next Page
Loading...
