Toshiba Strata CTX - Page 412

System Error Codes
System Programming Error Codes
B-2 Strata CTX Programming - Part 4: Appendices 04/03
System Programming Error Codes
Program Code FB
Sub-
parameter
Error Descriptions
100
33
)% The entered Cabinet/Slot value is out of range.
33
)% The entered PCB Type is out of range.
49
)%
Deleting a Card (000) – Programmed station and/or trunk data
must be deleted before a card can be deleted.
49
)%
Changing Card Type Code – Card Type cannot be changed.
Delete the existing Card Type before entering a new Card
Type.
49
)% The designated BIOU is already in use.
49
)%
The PCB cannot be assigned to the designated equipment
position.
50 )%
One of the required parameters (PCM Highway, BDKU Type
or TEI Assignment) has not been assigned.
50
)%
The PCM highway value entered is not applicable for the
desired PCB assignment. PCB parameters are required for
PDKU or BDKU, RDTU, RDSU, RPTU.
50
)%
The Channel Type value entered is not applicable for the
desired PCB assignment. PCB parameters are required for
PDKU or BDKU, RDTU, RDSU, RPTU.
50
)%
The TEI Type value entered is not applicable for the desired
PCB assignment. PCB parameters are required for PDKU or
BDKU, RDTU, RDSU, RPTU.
102
33
)% The entered Feature Code is out of range.
49
)%
An invalid OLG number was entered in OLG Number field
when assigning a Flexible Numbering Feature code of 551.
51
)%
Flexible Numbering Plan values cannot be repeated. The
value entered cannot be registered (e.g., If 1234 is registered,
123 cannot be registered).
52
)%
The value entered conflicts with an existing extension and
cannot be registered.
103 -  See “Common Error Code Table” on page B-1.
104 -  See “Common Error Code Table” on page B-1.
105
33
)%a)% The entered Clock value is out of range.
49
)%
)%
The BIOU general relay number value conflicts with existing
parameter assignments.
49
)%a)% The entered circuit number is not the clock source port.
106 -
 See “Common Error Code Table” on page B-1.
107
33 )%a)% The entered Pad device number is invalid.
96
)%a)% The number of Pad groups exceed the system capacity.