Toshiba Strata CTX - Page 424

System Error Codes
Trunk Programming Error Codes
B-14 Strata CTX Programming - Part 4: Appendices 04/03
316
33
)% RPTU Equipment Number entered is invalid.
49
)%
If the Span Interface speed is set to a value not equal to 1.5M,
the Dch position is modified.
52
)%
The entered channel group number conflicts with an existing
ISDN extension(s).
54
)%
The equipment number entered is out of range.
80
)%
The entered channel group number does not exist in the
system.
80
)% The entered circuit must be an assigned ISDN.
317
33
)% The entered equipment value is invalid.
49
)%
)%
The entered ILG/OLG values do not have ISDN assignments.
50 )%
The T-Wait Timer can only be enabled if the Protocol is set to
National ISDN.
52 )%
The entered channel group number conflicts with an existing
ISDN extension(s).
54 )%
The quantity of lines, ISDN channels and PDNs entered
exceeds the number of ports licensed with this processor.
80 )%
The entered channel group number does not exist in the
system.
80
)% The entered circuit must be an assigned ISDN.
80
)% The entered ILG number does not exist in the system.
80
)%
The entered OLG number does not exist in the system.
96
)%
The allowable channel group assignments exceed the system
capacity.
318
48
)%a
)%
No incoming destination number is assigned for the required
parameter.
49 )% The selected GCO conflicts with an existing ILG number.
49
)%
The selected Pool Line Group conflicts with an existing ILG
number.
80 )% The entered GCO key group does not exist in the system.
82 )% The selected ILG number does not exist in the system.
82
)%
The selected ILG number does not exist in the system. The
number of ILGs exceed the system capacity.
96
)%
)%
The number of allowable GCO or POOL key group
assignments has been exceeded.
319 48 )%a)% The destination number is not assigned.
Program Code
Occurred
FB
Sub-
parameter
Error Descriptions