Station
Assignment
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03 5-3
Station
10 Call Waiting Tone Select desired waiting tone for Offhook Campon.
Possible values: None (default), Singular or Continuity
11 Dialing Progress
Tone
Select type of Tone to hear after dialing LCR access code
Possible values: Dial Tone (default), Entry Tone or Silence
12 System Call
Forward.
Select the System Call Forward Group number.
Possible values: 0~4 (CTX100), 0~10 (CTX670 Basic), 0~32 (CTX670 Exp.),
(default = 0)
13 Call Pickup The station privilege to activate Call Pickup.
Possible values: Permitted (default), Group Only or Not Permitted
14 Bearer Capability ISDN Bearer Capability the PSTN is expecting from non ISDN stations.
Possible values: 3.1kHzAudio (default) or Speech
15 Display DN Enter the number to be displayed on the calling telephone that rings this PDN
number. This number is will be overridden by Program 209, 04 (if assigned) and if
the PDN is in a hunt group.
Possible values: Up to 5 ASCII characters (default = no value)
16 Caller Emergency
Service Identification
(CESID)
Enter the E911 Calling Party Information identifier for this station (CESID).
Possible values: Up to 16 digits (default = no value), however CESID should be 10
digits or less for Centralized Automatic Message Accounting
(CAMA) E911 trunk. PRI E911 allows upto 16 digits.
17 Emergency Call
Group
Enter the Emergency call group that this station belongs to.
Possible values: 1~8 (default = 1)
18 Remote CF/DND
Password
Enter password to set or cancel DND or station Call Forward from another CTX
station; or, for Call Forward only, from a external DSIA line.
Possible values: Up to 4 ASCII characters (default = no value)
Note DND can not be set/canceled remotely from a DISA line.
19 VMID Code SMDI Enter the voice mail box number that should answer calls when this PDN calls voice
mail; or, when this PDN is called and then forwards to voice mail (this number is
prefixed by codes in Program 579, 11~16)
Possible values: Digits 0~9, * and #, up to 10 characters (default = no value).
Note This VMID code is sent to the voice mail device in SMDI packets or DTMF
tones on direct calls to voice mail from the PDN; and on calls to the PDN
that forward to voice mail. See Program 580 for SMDI or DTMF choice.
22 MW to VM Port Enter the Message Waiting center DN. For Remote CTXs, assign message center
including Node IP for TPI integration. This parameter enables Call Record function
too.
Possible values: Up to 7 ASCII characters (default = no value)
23 Travelling COS
Change
Enable this station with the privilege to change the Travelling COS Override Code.
Possible values: Enable or Disable (default)
FIELD DESCRIPTION
To Next Page
Loading...
