5 Implement Application Controller
70 FM-750 Display User Guide
Field-IQ 12-section switch box
Note – The 12 section switch box is required for section control. For rate control only, the
switch box is optional.
Only one section switch box can be used on each system. Each section switch is
automatically assigned to the corresponding module. The modules are read from left
to right. For example, switch 1 assigns to the module furthest on the left when standing
behind the implement.
The section switches have different functions, depending upon the status of the master
Automatic/Manual section switch on the master switch box.
When the Automatic/Manual section switch is in the Automatic position:
• If the section switch is in the on/up position the section(s) assigned to it are
commanded automatically by the FM-750 display.
• If the section switch is in the off/down position the section(s) assigned to it are
commanded to be off.
When the Automatic/Manual section switch is in the Manual position:
• If the section switch is in the on/up position, the section(s) assigned to it are
commanded to be on. This overrides the FM-750 display and coverage logging is
ignored.
• If the section switch is in the off/down position, the section(s) assigned to it are
commanded to be off. This overrides the FM-750 display and coverage logging is
ignored.
The LED has the following status indicators:
• Green – The unit is powered and is communicating with the FM-750 display.
• Yellow – The unit is initializing communications with the FM-750 display.
• Red – The unit is powered but not communicating with the FM-750 display.
To Next Page
Loading...
