18 • System Power Up and Down User Guide Ver. 7.1.0 2100 Cap Inspector
Do not exit to Windows and shut down like turning off a
computer.
This will cause the software to get out of synchronization
with the power off relay on the controller card.
The system will now be looked up and cannot be restarted
with the Power Switch.
Correcting The Power On Lockup Condition
The solution is to disconnect the AC power cord from the
AC Outlet.
Please observe the Label on the rear panel of the tower.
See below
Wait 30 Seconds
This 30-second delay will insure that the relay has enough
time for its contacts to open before the power is turned back
on.
To Next Page
Loading...