Vibrac 2100 - Re-Application Options

User Guide Ver. 7.1.0 2100 Cap Inspector Creating a Removal & Bridge Test • 49
Re-Application Options
Application Torque: This is the torque that the cap will be
re-applied to after the removal and bridge measurements are
made.
Speed: This is the speed that the system will drive at until
the slow down point is reached.
Slow Down At: This is the torque value at which point the
drive will slow down to re-apply the cap at 1 RPM
Re-Application Torque
Observe the minimum and maximum
values.
To input a value, just start typing. The first key
selected will overwrite the first highlighted
value on the screen. When the desired value
has been keyed in press OK to save the new
value.
Re-Application Speed
Observe the minimum and maximum
values.
To input a value, just start typing. The first key
selected will overwrite the first highlighted
value on the screen. When the desired value
has been keyed in press OK to save the new
value.