98 • Cap Inspector Calibration User Guide Ver. 7.1.0 2100 Cap Inspector
Installing the Calibration Beam
The beam is installed by first removing any
bottle holding tooling and then carefully
placing the beam on top of the spindle cap.
Screws are provided for holding the beam in
place.
(2 x .250-20 x 1" Skt Hd Cap Screws)
(Wrench size
3
/
16
" Hex.)
The second step in the procedure is to select User
Verification on the Calibration Menu.
On the Main Menu press the button titled
Calibration
Now the complete Calibration menu will be
displayed as shown below.
Now select the Blue Button titled User
Verification.
The software will now advance to a series of
menus that will guide the user through the
process by just following the steps on the
screen.
Spindle Cap
To Next Page
Loading...