64 • Creating an ROPP CAP Test User Guide Ver. 7.1.0 2100 Cap Inspector
Bridge Options
Distance: This is the distance to drive when measuring the
torque required to break the Bridges after the removal torque
has been measured.
Initial Speed: This is the speed that the system will drive at
after the Removal measurement has been made.
Change Speed: This is the torque at which the system will
change to the speed for performing the bridge break.
Break Speed: This is the speed at which the bridges will be
broken.
Bridge Distance
Observe the minimum and maximum
values.
To input a value, just start typing. The first key
selected will overwrite the first highlighted
value on the screen. When the desired value
has been keyed in press OK to save the new
value.
Bridge Initial Speed
Observe the minimum and maximum
values.
To input a value, just start typing. The first key
selected will overwrite the first highlighted
value on the screen. When the desired value
has been keyed in press OK to save the new
value.
To Next Page
Loading...