Vibrac 2100 - Creating a Removal Torque Test; Whats Inside; Select Test Type; Keyboard For Removal Test

User Guide Ver. 7.1.0 2100 Cap Inspector Creating a Removal Torque Test • 33
Creating a Removal Torque Test
What's Inside
This chapter contains a step-by-step procedure for creating a
Removal Torque Test.
The procedure for displaying the select test type screen was
described in the previous chapter.
Select Test Type
On the Select Test Type screen select
Removal.
The software will advance to the Enter Profile
Name screen as shown below.
Keyboard For Removal Test
For this manual the profile name, Removal
has been entered.
Selecting OK will advance the software to the
Removal Test Setup Screen shown below.