32 • Test Types User Guide Ver. 7.1.0 2100 Cap Inspector
Test Definitions
The counter clockwise turning force required to remove an
applied closure from a bottle finish.
The Removal portion of this test is the same as described
above.
The Incremental portion is the clockwise turning force
required to tighten an applied closure six degrees beyond its
initial applied position.
The Removal and Incremental Test per Industry Standards is
always performed at 1 RPM and the distance to drive is
always six degrees when re-applying the cap.
The Removal portion of this test is the same as described
above.
The Bridge portion is the counter clockwise turning force
required to break the small strips of material that span the
gap between the cap and the tamper evident band.
The counter clockwise turning force required to rotate an
applied child resistant closure without any down force.
The clockwise turning force required to rotate the cap until
the threads on the bottle or in the cap fail.
The Removal and the Bridge potion of this test is the same
as described above. The Strip portion of this test measures
the turning force required in the clockwise direction to cause
the threads in the Aluminum Cap to fail.
To Next Page
Loading...