Vibrac 2100 - Strip Test Setup Screen; Strip Test Options

User Guide Ver. 7.1.0 2100 Cap Inspector Creating a Strip Torque Test • 57
Strip Test Setup Screen
The Strip Test Setup screen is divided into 3
parts.
1. Strip Options
2. Strip Pass / Fail Limits
3. Report Options
Strip Test Options
Minimum Torque: The torque value that must be exceeded
before the Strip Torque is measured.
Peak Detect: The number of degrees of rotation after a peak
has been measured for the software to accept this peak as the
Strip Torque value.
Cutoff Torque: When the Cutoff Torque is reached the test
will end.
Speed: The drive speed prior to slow down to 1 RPM test
speed.
Slow Down At: A programmed percent of application torque
to 1 RPM.
Strip Minimum Torque
Observe the minimum and maximum
values.
To input a value, just start typing. The first key
selected will overwrite the first highlighted
value on the screen. When the desired value
has been keyed in press OK to save the new
value.