Vibrac 2100 - Re-Application Slow down; Close Options; Application Torque

50 • Creating a Removal & Bridge Test User Guide Ver. 7.1.0 2100 Cap Inspector
Re–Application Slow Down
Observe the minimum and maximum
values.
To input a value, just start typing. The first key
selected will overwrite the first highlighted
value on the screen. When the desired value
has been keyed in press OK to save the new
value.
Close Options
Application Torque: This is the value that will be used when
the Close Button is pressed in the Removal and Bridge Test
Mode.
Speed:
Application Torque
Observe the minimum and maximum
values.
To input a value, just start typing. The first key
selected will overwrite the first highlighted
value on the screen. When the desired value
has been keyed in press OK to save the new
value.