Vibrac 2100 - Creating a Removal & Bridge Test; Whats Inside; Select Test Type; Keyboard For Removal and Bridge Test

44 • Creating a Removal & Bridge Test User Guide Ver. 7.1.0 2100 Cap Inspector
Creating a Removal & Bridge Test
What's Inside
This chapter contains a step-by-step procedure for creating a
Removal and Bridge Test.
Select Test Type
On the Select Test Type screen select Removal
and Bridge.
The software will advance to the Enter Profile
Name screen as shown below.
Keyboard For Removal and Bridge Test
For this manual the profile name, Removal &
Bridge has been entered.
Selecting OK will advance the software to the
Removal and Bridge Test Setup Screen shown
below.