TITANUS MICRO·SENS
®
Technical Description
MS_A_02-a-en-e Data: 01/09 2 – 5
Resetting through FAS A fault message is reset via the connected FAS. If whilst the TITANUS
MICRO·SENS
®
is operating an FAS alarm and fault [menages] have to
be reset at the same time as the control line, then as an option a reset
board
0F
1
can be inserted in a separate housing. The effect is that when
there is any short-term switching off of the line voltage, the alarm and
fault messages on the TITANUS MICRO·SENS
®
are automatically reset.
1
The reset board can only be placed in a separate housing and if the idle current on the
line is between 5 mA and 50 mA. The line must be switched to dead for resetting.
To Next Page
Loading...
