TITANUS MICRO·SENS
®
Installation
MS_A_05-en-e Data: 01/09 5 – 3
Aspiration
from below If the TITANUS MICRO·SENS
®
is installed with the aspiration pipe
underneath, ensure that no foreign bodies or drops of water can get into
the air outlet aperture which in this case is facing upwards. For that
reason, use a short pipe angled downwards (see Fig. 5.1).
With aspiration from below, the housing cover on the TITANUS
MICRO·SENS
®
must be turned by 180°.
1
Fig. 5. 2: Turn the cover of the TITANUS MICRO·SENS
®
detection unit
To turn the cover of the TITANUS MICRO·SENS
®
detection unit by 180
o
,
the following steps must be taken:
Turn cover
1
Release the 4 screws (for position see Fig. 5.2).
2
Now turn the cover and fix the detection unit again with the 4
screws.
ATTENTION
To Next Page
Loading...
