YAMAZAKI MAZAK VORTEX i Series User Manual

MACHINING PROGRAM 4
4-83
2. Program composition
Program composition element
Command of upper turret
Machining motion
Instruction in
Preparation motion
For machining
Upper turret
HD2
Milling
Command of lower turret
Machining motion
Instruction in
Preparation motion
For machining
Lower turret
HD1
Milling
G109L2
M901
M200
G0G90G94G55G97
G40G49G80G67G69
G91G28X0
G28Z0
M950
T001000
G91G28X0
G28Z0
G97M03S3000
G10.9X0
M51
M951
G90G43G0X-150.Z450.0 H1
M250
X-200.
G1Z440.F0.25
X-190.
G90G0X-150.
G40
M05
M952
M09
G91G28X0
G28Z0
M30
(Upper turret: HD2-Milling, Lower turret: HD1-Milling (2/2))
jiku
Preparation motion for machining
 G109L2: Lower turret selection
 M901: HD1 spindle selection
 M200: C-axis connect/Milling mode select
 G94: Feed per minute
 G97: Constant surface speed control OFF
 T001000: Tool change (TNo.01 Lower)
 G97S3000: Rotation speed 3000 min
-1
 M03: Milling spindle forward rotation
 G10.9X0: Radius data input mode
 M51: Milling spindle-through coolant ON
Machining motion
End motion for machining
 M05: Stop of milling spindle rotation
 M09: All coolants OFF
 Each axis positioning to zero return
 M30: Reset and rewind
Machining
Serial No. 294060
Copyright (c) 2013 YAMAZAKI MAZAK CORPORATION. All rights reserved.
Serial No. 294060

YAMAZAKI MAZAK VORTEX i Series Specifications

General

Brand	YAMAZAKI MAZAK
Model	VORTEX i Series
Category	Computer Hardware
Language	English