5 SUPPLEMENT
5-68
P-codes for waiting
Commands for upper turret
Commands for lower turret
3. Notes
Waiting commands (corresponding M- and P-codes) are all ignored in a hole
machining fixed cycle mode (G283 to G289). Cancel the hole machining fixed cycle
mode beforehand with G80 to give a waiting command.
A waiting command (M-code or P-code) must be given in a single-command block.
Use the waiting P-codes in the ascending order of their number, since one turret
cannot be released from the wait state until the program flow for the other turret
reaches a waiting P-code with the same or a larger number.
Serial No. 294060
Copyright (c) 2013 YAMAZAKI MAZAK CORPORATION. All rights reserved.
To Next Page
Loading...
Need help?
General
