YAMAZAKI MAZAK VORTEX i Series User Manual

4 MACHINING PROGRAM
4-24
B. Program composition
C. Parameter setting
The main parameter of processing is described.
The table shows the standard parameter and setting set in this manual.
Parameter setting
Parameter
bit
Standard
Setting
Description
F34
4
0
0
Programming type for inclined-surface machining. Always select
type A
F114
3
1
1
Moving axes by using G49 (tool length offset cancel) in G43 (tool
length offset) mode Invalid
F144
1
0
1
Selection of table rotary axis reference position for inclined-surface
machining Table rotary axis 0-degree position as the reference
Note 1: Type A: Combined use with the other 5-axis machining functions, and cannot allow
interruption during Inclined-Plane machining
Note 2: Type B: Combined cannot use with the other 5-axis machining functions, and allowing
interruption during Inclined-Plane machining
M108M212
G68.2P1XxYyZzIiJjKk
G53.1
M107M210
G90G43G00XxYyZzHh
G82ZzRrFf
(Drilling positioning)
G80
G69
Processing operation of program component –Hole machining-
--- Rotation axes unclamping
--- Inclined-Plane machining
Using roll, pitch, and yaw angle
--- Tool axis direction control
--- Rotation axes clamping
--- Tool length offset
--- Hole-machining fixed cycle
--- Drilling positioning
--- Fixed cycle OFF
--- Inclined-plane machining OFF
Because BC axes are moved by G53.1.
Rotation axes have to clamp
G82
G80
Fixed cycle
G68.2
G69
Inclined-plane machining
The figure below indicates setting
each mode.
Instruction in
machining motion
Instruction in
preparation motion
for machining
Program composition element
Upper turret
HD1
Milling
Tool length offset(P0)
Inclined-plane machining
Using roll, pitch, and yaw angle
Hole fixed cycle
Serial No. 294060
Copyright (c) 2013 YAMAZAKI MAZAK CORPORATION. All rights reserved.
Serial No. 294060

YAMAZAKI MAZAK VORTEX i Series Specifications

General

Brand	YAMAZAKI MAZAK
Model	VORTEX i Series
Category	Computer Hardware
Language	English