Aastra Ascotel IntelliGate 2065 - 4.4.3 Routing Functions with Outgoing Calls; 4.4.4 Other Functions and Settings of the CDE

Ascotel IntelliGate 2025/2045/2065
232 Routing elements Part 2
• Routing a call to data service destinations:
Data service destinations can be configured for each call distribution element
(see "Data services", page 353).
• Routing a call to external remote control:
This destination is normally allocated only once in every system to enable access
to external remote control via a DDI number. (See "Remote controlling features
from outside the system", page 544.)
4.4.3 Routing Functions with Outgoing Calls
Outgoing calls via the line keys of a key telephone are routed via the route entered
under "KT route" (see "Key Telephones", page 253).
4.4.4 Other Functions and Settings of the CDE
Name
"Name" is used to provide each call distribution element with a name. The name
is used for identification purposes.
• With incoming calls it is displayed on the system terminal.
• With outgoing calls via KT lines it is provided as CNIP.
The name cannot be used for dialling by name.
Displaying DDI
With incoming calls the direct dialling number can also be displayed instead of the
name of the call distribution ("DDI instead of CDE name = yes"). This is needed
for CTI applications in particular.
Activating / Deactivating Incoming Call Logging (ICL)
Incoming call logging can be activated or deactivated for each call distribution ele-
ment (see "Call logging for incoming calls (ICL)", page 379).
Specifying the Company Configuration
The "Company" setting specifies whether or not the call distribution element is
to be used in a two-company configuration (see "Two-company system", page
250).