Ascotel IntelliGate 2025/2045/2065
688 Planning a private network Part 3
Variant 2:
1. In system 1 select the settings for route 1-1:
– Numbering plan identifier (NPI) = E.164
– Digit barring = yes
2. In system 2 select the settings for route 2-1:
– Numbering plan identifier (NPI) = PNP
– Send access code = 0 (as the exchange access prefix)
– Digit barring = yes
3. In system 3 select the settings for route 3-1:
– Numbering plan identifier (NPI) = PNP
– Send access code = 0 (as the exchange access prefix)
– Digit barring = yes
6.2.4 Creating the numbering plan
Now that the network is defined through the definition of the routes and trunk
groups, we need to specify the numbering within the network.
In the following we shall be looking at both methods described on page 675.
To Next Page
Loading...
