Aastra Ascotel IntelliGate 2065 - 8.1.5 Features operated via QSIG

Ascotel IntelliGate 2025/2045/2065
Part 2 Features 431
8.1.5 Features operated via QSIG
In private QSIG networks a number of features can be operated on third-party
PINXs via QSIG (applies only to Ascotel IntelliGate systems among themselves). In
such cases it is irrelevant whether the QSIG networking is effected via a basic
access, a primary rate access or Ethernet connections (IP network with AIP 6400),
and which QSIG variant is selected as the protocol. The executing subscriber
obtains (visual) confirmation as to whether or not the feature was successfully car-
ried out.
Subscriber-unrelated Features
Subscriber-unrelated features are operated via abbreviated dialling numbers
defined on the destination PINX and containing the corresponding procedures.
These abbreviated dialling numbers are entered on one's own PBX as PISN sub-
scribers in the numbering plan.
Note:
Make sure that these abbreviated dialling numbers are barred in the
digit barring on all PINXs for unauthorized subscribers and that no
names are assigned to the abbreviated dialling numbers (bypassing the
digit barring).
The following procedures are supported:
Tab. 2.127: Subscriber-unrelated QSIG features
Subscriber-related features
Operation of the subscriber-related features is subject to the definition of the PISN
subscribers in one's own numbering plan. The features can be divided into two
groups:
Feature Activate Deactivate
Operate switching groups *85<Swith group><Pos.>
Actuate door opener *751, *752
Switch relays *755 - 757 #755 - 757
Enable/bar a one-off remote access
*754 #754
Answer coded ringing on general bell *82
Answer ring call on general bell *83
Dial door intercom 851,852 (initialisation values)