Ascotel IntelliGate 2025/2045/2065
Part 7 Data Maintenance 899
The handset remains fully functional while an AIR upload is in progress. The new
loaded software is activated only once the upload has been successfully com-
pleted. A reset is carried out on the handset.
If the handset does not have a functional software, the software has to be loaded
via the Iris box using the Office 135 adapter in the case of the Office 135, or via
the Doris adapter in the case of the Office 155pro .
Office 100 and Office 150 handsets
The software for the Office 100 and Office 150 handsets is stored in the Flash
memories.
• The software for the Office 100 handset is updated via the Iris adapter.
• The software for the Office 150 handset is updated via the Doris adapter.
Software upload via radio (AIR upload) is not possible on the Office 100 and
Office 150 handsets.
2.3 Updating the PBX boot software
The boot software is stored on the Flash board in a parallel Flash memory (see Fig.
7.3). To update the boot software, you need to replace the Flash card:
Procedure:
1. Preliminaries: Use AIMS to save the configuration data (see "Exchanging data
between PBX and PC", page 153).
2. Replacing the Flash card: Carry out steps 2-11 as described in "Replacing the
Flash Card", page 961.
3. Use the Upload Manager to load the system software (see "Updating system
software and terminal software", page 890).
4. Use AIMS to reload the configuration data (see "Exchanging data between
PBX and PC", page 153).
To Next Page
Loading...
