Ascotel IntelliGate 2025/2045/2065
Part 3 Planning DECT systems 641
5.5.3 Switching radio units
Since call connections between test handsets can only be made via the same test
radio unit, it is important to know how to use the test handset to switch to
another test radio unit. The "Automatic" mode lets the handset choose the radio
unit and is therefore not recommended.
Fig. 3.36: Setting the switchover to another test radio unit on the test handset
Standard handset operation
The standard handset corresponds to the normal system handset and can also be
used for planning purposes.
Here we shall only be discussing the procedures required for planning.
To switch between normal mode and test mode ("TEST" displayed), proceed as
follows:
• From normal mode to test mode:
– Press the "M" key repeatedly until "PRG1" appears.
– Now press the "M" key repeatedly until "Test" appears.
– Press the Foxkey when "Test" appears.
• From test mode to normal mode
– Press the "C" key repeatedly until you exit the test menu.
Menus in the test mode:
Two menus are available when you access the test mode (see menu structure in
Fig. 3.38 to Fig. 3.42).
Internal Menu
repeat
until
2.1.
2.1.
Station Selection
Go Back
OK
Station A
Go Back
OK
repeat
until
Options: Automatic, Station A (B/C/D)
haz0338aaena0
To Next Page
Loading...
