Ascotel IntelliGate 2025/2045/2065
284 Call Routing Part 2
Configuration for through KT lines
• In the call distribution configure "KT line and user group" as the destination
• Delay the elements of the user group.
The user group is therefore an additional distributor if all the addressed through
KT lines are busy..
Using a Voice Mail System
Unanswered calls can also be forwarded to a Voice Mail System where they are
processed (see "User Groups for Voice Mail and Other Applications", page 243).
5.2.3.3 Not Forwarding a Call if busy
If the caller is to obtain the busy tone when the subscriber is busy, the following
configuration recommendations must be observed:
• Do not configure an alternative destination if busy (leave the "CDE if busy" set-
ting blank).
• Do not configure Call Forwarding on No Reply if busy
• Disable call waiting on exchange connections in the system configuration
• Disable local call waiting using *04
Note:
If a fax machine is connected to an internal user-network interface, dis-
able "Call waiting".
5.2.3.4 Release Destination if Incoming Dialling is
Incomplete
1)
If the direct dial number is incompletely dialled the outside call will be routed to
the call distribution element allocated to the trunk group after 8 to 15 seconds
(depending on the country) and then forwarded to the destinations entered there.
1)
Only in countries in which digit-by-digit DDI is implemented in their public exchanges.
To Next Page
Loading...
