Ascotel IntelliGate 2025/2045/2065
912 Hardware updates and system expansion Part 7
3.5.1.2 Terminals with a different level of added features
Given that every level of added features on system terminals has a certain number
of features, the features are adapted (reduced or increased) to the new terminal
whenever the terminal definition is changed. The features are reduced if a termi-
nal is replaced by a terminal with a lower level of added features (e.g. Office 45
→ Office 10 to Office 35) or by a predecessor model (e.g. Office 45 → Office 40).
If a system terminal is replaced by a system terminal of a different level of added
features, the terminal display will display the message "Incorrect set type". On the
Office 10 the LED flashes slowly. In this situation, although the terminal can be
used for basic telephone operations, none of the added features will be available.
Before the added features of the new system terminal can be used, the new ter-
minal type will have to be entered in the PBX using the AIMS Configuration Man-
ager "Terminal data" or by configuring at the terminal.
3.5.2 DECT terminals
Replacing a radio unit
1. Dismantle the defective radio unit.
2. Fit the new radio unit.
For information on installing radio units, see "Installing the radio units", page
829.
Replacing a handset
1. Log off the previous DECT subscriber via AIMS.
2. Log on the new handset (see "Configuration Steps", page 853). The handset
data is preserved until the subscriber number is also deleted.
To Next Page
Loading...
