Ascotel IntelliGate 2025/2045/2065
Part 7 Hardware updates and system expansion 905
Tab. 7.3: Displays on the 7-segment display
The system is prebarred in the AIMS Configuration Manager under "Card config-
uration": press the "Prebar system configuration"button.
As soon as there are no more active connections in the prebarred system, the sys-
tem can be taken out of operation.
Note:
Prebarring the system can be dispensed with if all concerned are aware
that existing connections will be disconnected.
Switch off the PBX
When using a UPS disconnect the battery first, then disconnect the PBX and any
external Auxiliary Terminal Power Supply (ATPS) from the 230 V mains.
Hazard:
Expansion cards can be damaged by electrical voltage.
Always disconnect the power supply before fitting or removing any
cards!
Fig. 7.7: Warning plate on the PBX
Horizontal bar display Meaning
the bottom line System prebarred
the middle line Active internal connections
the top line Active external connections
1
2
haz1254aaxxa0
To Next Page
Loading...
