Aastra Ascotel IntelliGate 2065 - Page 938

Ascotel IntelliGate 2025/2045/2065
938 Operations supervision Part 7
5. Test the AKB and EKP supplementary equipment:
All the LED displays on the connected supplementary equipment are flashing.
Test keys: Press one key after the other.
Each keystroke generates a tone in the loudspeaker. Pressing the keys "Shift",
"Control" and "Alt" does not generate a tone.
6. To exit the self-test mode, unplug then reconnect the terminal connecting
line.
Should any irregularities occur during the self-test, contact a specialist.
Test procedure for Office 20, Office 30, Office 40
1. Unplug the terminal connecting line from the connection socket; with the
Foxkey on the outer left pressed down, reconnect the terminal connecting
line. Once the self-test mode has started, release the Foxkey.
2. Office 20 automatic test: All the display symbols appear.
Office 30, Office 40 automatic test: The LEDs go on and off, and the display
symbols alternate continuously between lit and off.
3. Key test (Office 20): Do not pick up the handset.
Key test (Office 30, Office 40): Pick up the handset and press one key after
the other.
Each keystroke generates a tone in the loudspeaker.
4. Microphone and earpiece are connected with each other: Blow into the
microphone; you should be able to hear the noise in the earpiece.
5. Press the loudspeaker key (Office 30, Office 40 only):
The hands-free microphone is briefly connected with the earpiece. The ambi-
ent noise is audible.
6. To exit the self-test mode, unplug then reconnect the terminal connecting
line.
Test procedure for the additional keypad (ZTF)
1. Unplug the terminal connecting line, then plug the connector back in again
while keeping the topmost key pressed down.
The ZTF LEDs go on and off.
2. Press any key on the ZTF.
Only the LED of the pressed key lights up.