Ascotel IntelliGate 2025/2045/2065
962 Generation Change Part 8
Warning:
Flash cards can be damaged by electrostatic discharge (ESD).
Always touch the earthed metal cage of PBX before touching a Flash
card.
Procedure:
1. If necessary carry out the preparations as described in "System Upgrade
2065", page 959 and "Updating the PBX boot software", page 899.
2. Switch off the PBX. When using a UPS disconnect the battery first, then dis-
connect the PBX and any external Auxiliary Terminal Power Supply (ATPS)
from the 230 V mains.
3. Dismantle the housing cover, then the cover to the power supply area.
4. Before handling the Flash card, touch the earthed metal cage of the PBX.
5. Remove the old Flash card from the PBX.
6. Take the new Flash card out of its ESD protective sleeve.
7. Fit the Flash card into the same system slot on the PBX (Fig. 8.2). Make sure
that the side notch on the connector tab is pointing towards the socket outlet.
8. Wrap the Flash card in the ESD protective sleeve.
9. Fit the cover on to the power supply area
10. Fit the housing cover.
11. Connect the PBX and any ATPS system to the 230 V mains, then connect the
UPS battery where applicable.
haz0001aaxxa0
To Next Page
Loading...
