ABB ACS6080 - Page 13

FIGURES
PRODUCT
ACS6000
DOCUMENT KIND
User manual
DOCUMENT ID.
3BHS212794 E01
REV.
N
LANG.
en
PAGE
13/266
Figure 6-2 Grounding the input side (A) and output side (B) of the
drive system .....................................................................................................................119
Figure 6-3 System ground connection (1) in a 600 mm TEU ..................................... 120
Figure 6-4 Grounding the EXU ..................................................................................... 121
Figure 6-5 Cable tray and cable ducts in an LSU (A = front) ................................... 122
Figure 6-6 Arc Guard System™ in an optional roof extension box (REB) ................ 123
Figure 6-7 Location of Arc Guard sensors in a TEU ................................................... 124
Figure 6-8 Cable tray and cable ducts in an LSU (A = front) ................................... 124
Figure 6-9 Cable entry with type 1 sealing modules ................................................ 125
Figure 6-10 Cable entry frame with type 1 sealing modules ................................... 126
Figure 6-11 Cable entry with type 2 sealing modules ............................................... 127
Figure 6-12 Cable gland ................................................................................................. 127
Figure 6-13 Cable entry with EMC plates ................................................................... 128
Figure 6-14 TEU 1000 mm cabinet (A = back) with top (1) and bottom
(2) cable entries ............................................................................................................ 129
Figure 6-15 Short busbar removal in ARU .................................................................. 130
Figure 6-16 EXU with top cable entry (A) and EXU with bottom
cable entry (B) .................................................................................................................131
Figure 6-17 EXU cabinet ................................................................................................ 131
Figure 6-18 Preparing power cables for sealing modules ....................................... 133
Figure 6-19 Prepare power cables for cable glands ................................................. 134
Figure 6-20 Preparing cables for EMC plates: (A) cables with an outer
screen or shield, (B) cables without an outer screen or shield or (C)
cables in an EXU cabinet ............................................................................................. 135
Figure 6-21 Cable connections in an EXU cabinet .................................................... 136
Figure 6-22 Minimum distance between bolted joints of different phases
in an EXU ....................................................................................................................... 137
Figure 6-23 Bolted busbar connection - marine drives ........................................... 137
Figure 6-24 Bolted busbar connection - non-marine drive ..................................... 138
Figure 6-25 Cable entry with sealing modules ........................................................... 140
Figure 6-26 Preparing control cables for sealing modules ..................................... 140
Figure 6-27 Preparing auxiliary control cables for cable glands ............................ 141
Figure 6-28 Preparing the screens of control cables for EMC plates .................... 142
Figure 6-29 Preparing control cables for EMC plates .............................................. 143
Figure 6-30 Top cable entry of 600 mm COU ........................................................... 144
Figure 6-31 Cable route in COU (600 mm) top cable entry ....................................... 144
Figure 6-32 Cable route in COU (1000 mm) top cable entry ..................................... 145
Figure 6-33 Cable route in COU (600 mm) bottom cable entry .............................. 145