ABB ACS6080 - Page 14

FIGURES
PRODUCT
ACS6000
DOCUMENT KIND
User manual
DOCUMENT ID.
3BHS212794 E01
REV.
N
LANG.
en
PAGE
14/266
Figure 6-34 Cable route in COU (1000 mm) bottom cable entry ............................ 146
Figure 6-35 Shield grounding point for encoder cable on NTAC pulse
encoder (A) and synchronous serial interface (B) .................................................... 147
Figure 6-36 Cable routing examples in an EXU cabinet with an ED5V,
EB5R, EB5S, EB7P and EB7Q type DCS800 converter (A) and in an EXU
cabinet with an ED7Y type DCS800 converter .......................................................... 148
Figure 6-37 DCS800 converter (ED5V, EB5R, EB5S, EB7P and EB7Q types) ........... 149
Figure 6-38 COM-8x circuit board (A) in a DCS800 converter (ED5V,
EB5R and EB5S types) and a detail of channel CH0 (B) on the board. .................... 149
Figure 6-39 Cable routing example in an EXU cabinet with an ED5V,
EB5R, EB5S, EB7P or EB7Q type DCS800 converter ................................................. 150
Figure 6-40 DCS800 converter (ED7Y) ........................................................................ 151
Figure 6-41 COM-8x circuit board (A) in a DCS800 converter (ED7Y type)
and a detail of channel CH0 (B) on the board .............................................................151
Figure 6-42 Cable routing example in an EXU cabinet with an ED5V,
EB5R or EB5S type DCS800 converter ....................................................................... 152
Figure 6-43 REB cable entry .......................................................................................... 154
Figure 6-44 Heating cable connection ...................................................................... 155
Figure 8-1 ARU control panel ........................................................................................ 162
Figure 8-2 INU control panel for motor 1 (A) and additional motors (B) ................. 163
Figure 8-3 Typical semi-redundant drive configuration ........................................... 164
Figure 8-4 Typical full-power (A) and half-power (B) drive modes ........................ 165
Figure 8-5 DCS800 control panel ............................................................................... 166
Figure 8-6 CBU grounding switch in ungrounded (A) and grounded (B) ................ 168
Figure 8-7 Safety switches ............................................................................................ 170
Figure 8-8 Grounding switch in ungrounded position .............................................. 176
Figure 8-9 Arc Guard System™ in a WCU REB ........................................................... 183
Figure 8-10 HMI panel .................................................................................................... 183
Figure 9-1 CDP control panel ...................................................................................... 185
Figure 9-2 Control panel functions for Actual signals mode .................................. 188
Figure 9-3 Control panel functions for Parameters mode ...................................... 195
Figure 9-4 Control panel functions for Functions mode ........................................ 200
Figure 10-1 Device identification ................................................................................. 208
Figure 10-2 Cable and wire designation ................................................................... 208
Figure 10-3 LEDs of AMC circuit board ...................................................................... 212
Figure 10-4 TB820 bus modem .................................................................................. 213
Figure 10-5 Example of S800 I/O station ................................................................. 214
Figure 10-6 Status LEDs on optional air-to-air heat exchangers ............................. 215