EasyManua.ls Logo

ABB ACS6080 - Page 15

ABB ACS6080
266 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FIGURES
PRODUCT
ACS6000
DOCUMENT KIND
User manual
DOCUMENT ID.
3BHS212794 E01
REV.
N
LANG.
en
PAGE
15/266
Figure 10-7 Grounding switch ungrounded ............................................................... 219
Figure 10-8 Grounding switch grounded ................................................................... 219
Figure 10-9 Grounding switch grounded ................................................................... 222
Figure 10-10 Testing the white lamp .......................................................................... 225
Figure 10-11 Safety switch on an ARU/INU cabinet door ......................................... 227
Figure 10-12 Safety switch settings ........................................................................... 228
Figure 10-13 Four-way grounding set ........................................................................ 229
Figure 10-14 TEU ground ball stud locations ............................................................ 230
Figure 10-15 ARU/INU ground ball stud locations .................................................... 231
Figure 10-16 Manual output isolation overview ........................................................ 232
Figure 10-17 Input module A2511 ................................................................................ 233
Figure 10-18 Tools for removing the busbar connectors ......................................... 234
Figure 10-19 Overview of grounding the drive - INU1 is shut down (A)
and INU2 is shut down (B). Numbers indicate the connection sequence. .............. 235
Figure 10-20 Connect the grounding sets in COU1 (A and C), TEU1 (B),
INU1 (D) and INU2 (E) ................................................................................................... 236
Figure 10-21 Busbar connector removal sequence in TEU1 or COU1 ........................ 237
Figure 10-22 Fitting sequence for busbar connectors ............................................... 238
Figure 10-23 Phase module removal .......................................................................... 241
Figure 10-24 COU filter ................................................................................................ 245
Figure 10-25 Accessing the fan units in the WCU roof box ....................................... 247
Figure 10-26 Air-to-air heat exchanger overview (type LT-5-5165-UL) ................... 248
Figure 10-27 Wire connection points on the circuit board ...................................... 251
Figure 10-28 DCS800 controller - size D4 .................................................................... 258
Figure 10-29 DCS800 controller - size D5 ................................................................... 260
Figure 10-30 Air-to-water heat connections ............................................................. 263
Figure 10-31 Lift heat exchanger out of EXU cabinet ................................................ 263

Table of Contents

Related product manuals