Version 16.10 AF-6600 AF-5000 Series Install Manual 116
P/N: 32021 AFS ADS-B Optional Install Kit
The optional AFS ADS-B install kit includes the following compontents:
Item QTY Part Number Description
1 1 50109F DB-9 Connector
2 1 50109S DB-9 Connector Shell
3 9 50100M Male DSUB Pins
4 1 73125 Ball and Stick UAT Antenna
5 2 50011 BNC Male Crimp Connector RG-142 (Antenna end)
The AF-ADSB is designed to be mounted in any convenient location in the cockpit, the cabin, or an
avionics bay.
The following installation procedure should be followed, remembering to allow adequate space for
installation of cables and connectors.
• Select a position in the aircraft that is not too close to any high external heat source. (The AF-
ADSB is not a significant heat source itself and does not need to be kept away from other
devices for this reason).
• Avoid sharp bends and placing the cables too near to the aircraft control cables.
• Secure the AF-ADSB to the aircraft using its four (4) mounting holes. The device should be
mounted to a flat surface. The mounting tabs on each side of the module have holes sized for
#8-32 fasteners, but it is up to the installer to decide how the module will be secured to the
aircraft.
Additional items you will require, but which are not in the AF-ADSB package, include:
• Antenna and fixing hardware. Antenna selection suggestions are available in the following
section.
• Cables and female BNC connector. You need to supply and fabricate all required cables.
Guidance on cable types is given below.
• Mounting hardware: To secure the AF-ADSB to the aircraft.
Electrical Installation
Because the AF-ADSB can be mounted in a variety of locations, the harness length requirements will
vary from airplane to airplane. Therefore, Advanced Flight does not supply pre-manufactured
harnesses for the AF-ADSB. Instead, your AF-ADSB shipped with the required D9 connector and pins to
generate a suitable harness. Refer to the sections below for detailed wiring information.
To Next Page
Loading...