Version 16.10 AF-6600 AF-5000 Series Install Manual 38
External Device Installation
71410 SV-ARINC 429 ADAPTOR
The SV-ARINC adaptor lets an AF-5000 EFIS connect to a GPS Navigator (Avidyne IFD540, Garmin GTN-650/750) using
the Advanced-SV network. This eliminates the need to use an EFIS serial port for GPS navigator communication.
AFS does not provide mounting hardware with SV-ARINC-429 module. The mounting tabs on each side of the module
have holes sized for #10 fasteners, but it is up to the installer to decide how the SV-ARINC-429 will be secured to the
aircraft.
Follow recommended torque practices when tightening the mounting hardware. Do not rivet the SV-ARINC-429 to the
aircraft as this will hinder future removal if necessary.
Advanced-SV Network Connection
Connect the SV-ARINC-429 module to the Advanced-SV network using the hardware mentioned in the Advanced-SV
System Construction Section or using equivalent hardware.
If you have to install a connector on the end of a network cable, insert all pins into the D9 connector. Refer to
Appendix C: Electrical Connections for details on connector pin-outs and wire colors. Remember to configure the
Advanced-SV network after connecting all modules to a display.
ARINC-429 Device Connection
Harness Construction
Because the SV-ARINC-429 can be connected to a variety of devices, the harness requirements will vary from airplane
to airplane. Therefore, AFS does not supply pre-manufactured harnesses for the SV-ARINC-429 module. Instead, your
SV-ARINC-429 shipped with enough connectors and pins to generate a wide variety of harness configurations. Refer to
the sections below for detailed wiring information.
If you do not own a D-sub machined-pin crimping tool, they can be obtained for under $50 from many retailers. See
http://wiki.dynonavionics.com for known sources of these products. You may also find it helpful to own a pin
insertion/extraction tool as well.
Additional harness construction and wiring information can be found in Appendix C: Electrical Connections.
The SV-ARINC-429 has a single 25 pin female D-Sub socket which is used for all data connections to your compatible
ARINC-429 device. The pin out depicted in Figure 82 below depicts the view from the rear of your male D25 connector
– the view you will have of your harness connector as you are inserting pins into the harness. Note that the pin
numbers are labelled on the face of both the female and male connector.
To Next Page
Loading...