EasyManua.ls Logo

Advanced AF-6600 - Page 75

Advanced AF-6600
267 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Version 16.10 AF-6600 AF-5000 Series Install Manual 75
Post Installation Checks
Ground Tests
1. Do all AF-COM-T25 buttons and knobs function normally?
2. Does the (optional) FLIP/FLOP pushbutton swap the STBY and COM frequencies?
3. Does pushing the PTT switch cause the AF-COM-T25 to transmit (only) when pushed? DO NOT
TRANSMIT WITHOUT AN ANTENNA CONNECTED. DOING SO WILL DAMAGE YOUR AF-COM-T25 RADIO.
5. Temporarily install a VSWR meter between the AF-COM-T25 and the antenna. Using brief test
transmissions, is the VSWR 3:1 or below? The maximum acceptable VSWR for A SV-COM-T25 is 3:1.
6. When transmitting on SV-COM-T25, is there any interference to other aircraft systems?
7. Power off the AF-6600 / AF-5000 display(s). The SV-COM-T25 should continue to operate normally,
with the exception that auto-population of frequencies will not occur, and a NO SV error message will
appear approx. 3 seconds after SV is not operating.
In Flight Tests
1. Does the AF-COM-T25 receive other aircraft and ground transmissions at reasonable ranges?
2. Is received audio clear at most volume levels on the AF-COM-T25? (Distortion at high volume levels
is normal.)
3. Are transmissions from the AF-COM-T25 heard by others at reasonable ranges? (Keep in mind that
the power output of the AF-COM-T25 is 6 watts.)
4. Are transmissions from the AF-COM-T25 clear (when received by others)?

Table of Contents