Operation Manual 137
10 Settings
About Settings 138
Service Mode 139
About 141
Calibration 142
Maintaining EPC calibration—inlets, detectors, PCM, PSD, and AUX 143
To zero a specific flow or pressure sensor 144
System Settings 145
Configuring the IP address for the GC 146
To set system date and time 147
To change the system locale 148
To set system power saving features 149
To access stored run data 150
To control Browser Interface access 150
To change the Remote Advisor settings 151
To change the miscellaneous settings 154
To run the system setup routine 155
Tools 156
Performing a column compensation run 157
Power 158
To Next Page
Loading...
Need help?
General
