4Touchscreen Operation
Operation Manual 57
Flow path page
The flow path page provides details on sample flow through the GC. This includes visual
indications of whether an ALS is installed on the GC, the inlet type(s), column setup, and
detector type(s), along with corresponding setpoints. See Figure 15.
Figure 15. Home view - flow path page
Selecting a setpoint brings up the method editor with the selected setpoint displayed. If the
setpoint is enabled, the keypad used to set the setpoint value is displayed.
Selecting a component, or a setpoint which is not currently enabled, brings up the method
editor with the component displayed but without the keypad displayed. See “Methods”.
When you edit a method in this way, changes are immediately applied when a parameter value
is changed, without the need to apply the changes to the GC. This is referred to as On-the-fly
editing. See “Editing the Active Method” for more information.
To Next Page
Loading...
