Agilent Technologies 93000 SOC Series - Page 133

Lesson 2 – Addressing the Analog Modules
133
SPA: Dual High Speed Sampler (1 GHz 12-bit)
SPB: 3GHz Sampler (3 GHz 12-bit)
TIA: Time Interval Analyzer (High Performance or General
Purpose TIA)
MCA: Multi-site Baseband Analog Measure
NOTE For the TIAs and the WGC, the slot locations shown here are the
locations of the frond-end cards for these analog instruments. The
actual instruments are installed in the analog support rack of the test
system.
The fill order of analog modules (in the Agilent 93000 SOC Series
Configuration Guidelines) is as follows. In the figure, for example,
“WGB/D -n” indicates either the High Speed AWG (WGB) or 500M
AWG (WGD), and n is the fill order.
Fill Order of Analog Modules
In the above figure, if necessary, digital channels can occupy group
6, 7, and/or 8 instead of analog modules according to the fill order
of digital channels:
512 pin testhead: 1 > 2 > 3 > (8)
1024 pin testhead: 1 > 2 > 3 > 4 > 5 > (7) > (6) > (8)
Group 8 Group 6Group 7 Group 2
1
2
3
4
1
2
3
4
1
2
3
4
1
2
3
4
5
6
7
8
5
6
7
8
5
6
7
8
5
6
7
8
224
WGA/E -3
222
WGB/D -2
220
WDB/E -5
219
WDA/D/G -5
218
SPA/B(5,6)
217
Blank
232
WGA/E -1
230
WGB/D -1
228
WDB/E -1
227
WDA/D/G -1
226
SPA/B(1,2)
229
WGC/F -1/3
225
TIA -1A/B
116
111
112
114 110
113 109
216
WDB/E -3
212
WDB/E -2
211
WDA/D/G -2
210
SPA/B(3,4)
213
WDB/E -4
209
TIA -2A/B
SOURCE SOURCE MEAS MEASMEASMEAS Digital Digital
221
WGC/F -2/4
231
WGA/E -2
223
WGB/D -3
215
WDA/D/G -3
115
214
WDA/D/G -4
Small Testhead
Large Testhead
Cage6 Cage8Cage4 (small TH)
Cage2 (large TH)
Cage2 (small TH)
Cage4 (large TH)
MCA Source&Measure module: 231=>232=>224
MCA Measure module: Same as for WDB